Home >> News

HOT PRODUCTS

    Shijiazhuang wufeng thermal machinery Co.,LTD is a company

    Shijiazhuang wufeng thermal machinery Co.,LTD is a company that specialize in manufacturing the glass m-at treatment furnace. The production base locates in the convenient transport Shijiazhuang wufeng thermal machinery Co.,LTD is a company that specialize in manufacturing the
    Shijiazhuang wufeng thermal machinery Co.,LTD is a company that specialize in manufacturing the glass m-at treatment furnace. The production base locates in the convenient transport Shijiazhuang wufeng thermal machinery Co.,LTD is a company that specialize in manufacturing the

    Scrubbing method of tempering furnace

     Shijiazhuang Wufeng Thermal Machinery Co., ltd. is committed to providing customers with the high-quality products and service. Customer satisfaction is our biggest target. We introduce the following scrubbing methods of tempering furnace:
     
      1. Tempering furnace temperature downs to room temperature,raise the furnace body, put the safety pin.
     
      2. Put the hard and nondeformable wood frame (width 400 mm - 500 mm) on the sides of underneath furnace body. If the furnace body is putted in a special furnace frame, wood frame can not focus on the sides of the underneath furnace body, it will crush rollers.
     
      3.The operator conducts their work by climbing to the woodern frame.
     
      4. If it is a blast furnace or pit furnace, first you should clean the glass on the troller with suitable strength. You can use a amall shovel to tick them off if the glass glues tightly. With the strongh strength, the roller would break. You need to clean the glass if they are under the stove.
     
      5. If the bottom broken glass crushed thermocouple, electrician must repair it.
     
      6. After cleaning, roller turns toward one direction, you could put the sand paper on the table with the hand, sliding around, clean the dirty things off with suitable strength.
     
      7. Each roller need to burnish, the smooth surface is controlled by yourself.
     
      8. Every roller need to burnish uniformly, not differ too much.
     
      9. Badly damaged roller could put into the furnace.
     
      10. Use the cleaner to clean the bottom, first with soft water to clean the roller, then with carbon tetrachloride to dry it cleanly.
     
      11. Pull out the safety pin and close the furnace.
     
      Our company has a good image, professional technology and orders welcome.

    Previous news:The emergency troubleshooting methods of glass tempering furnace

    Next News:Attentions for glass tempering furnace

Home|About us|Products| Honor|Project|News| Contact us

Copyright©2000-2015 Shijiazhuang Wufeng Thermal Machinery Co.,Ltd. All Rights Reserved